Still no remedy for the engine recall. Vehicle gives me issues. Currently will not start, can not move the vehicle away from my driveway. Has bunch of electrical errors.

The contact owns a 2024 Jeep Wrangler. The contact stated while driving at an undisclosed speed, the accelerator pedal was depressed, however the vehicle failed to accelerate as intended. The contact stated that the check engine and cruise control fault warning lights illuminated. The contact stated that the vehicle did not accelerate about 53 MPH. In addition, the contact stated that the failure occurred while the contact was driving on the highway. The vehicle was taken to the dealer, where the contact was informed that the failure was not duplicated. In addition, the contact stated that the recall, NHTSA Campaign Number: 25V766000 (Engine) was completed on May 20, 2026. The failure occurred the following day. The manufacturer was made aware of the failure and a case was filed. The failure mileage was approximately 47,978.

What component or system failed or malfunctioned, and is it available for inspection upon request? The vehicle experiences a severe front-end steering and suspension oscillation commonly referred to as “death wobble.” After driving over uneven pavement, bridge joints, potholes, or rough highway surfaces at highway speeds, the steering wheel begins violently shaking side-to-side and the front suspension appears to oscillate uncontrollably. The vehicle becomes difficult to steer and maintain lane control until speed is significantly reduced. The issue first occurred at approximately 10,000 miles and has recently returned. Although the current episodes are somewhat less severe than the initial event, the vehicle still becomes unstable above approximately 65 mph and cannot be safely driven at normal highway speeds. How was your safety or the safety of others put at risk? This defect creates a serious safety hazard because the steering instability occurs suddenly at highway speeds and makes the vehicle feel temporarily out of control. During the initial in incident, the steering wheel shook violently after hitting an uneven section of highway pavement, and I believed I could lose control of the vehicle or collide with surrounding traffic. The only way to stop the oscillation is to rapidly reduce speed to approximately 50 mph or lower, which itself creates additional danger from surrounding vehicles traveling at highway speed. The recurrence of the issue has made me afraid to drive the vehicle on highways or at normal traffic speeds due to concern over loss of steering control and potential crash risk. Has the problem been reproduced or confirmed by a dealer or independent service center? The vehicle was serviced. The dealer performed the fix of the wheel damperer after the original occurrence. While those actions temporarily reduced the severity of the symptoms, they did not permanent. This is a known issue for Jeep's since 2018, I have had 3 and all 3 have had it

The contact owns a 2024 Jeep Wrangler. The contact stated that while driving, the contact accelerated to merge on to the highway and the vehicle would not accelerate past 55 to 60 mph. The contact exited the highway and the vehicle began to shaking, vibration and stalled. The vehicle was able to restart and was taken to a dealer where it was diagnosed with engine failure associated with NHTSA Campaign Number 25V766000 (Engine). The vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 40,000.

Yesterday evening we were driving and the orange check engine light came on. Followed by a red battery light, the red turtle and an exclamation point with a car and a speedometer symbol. It would not let me switch to electric e-save and kept me in hybrid mode. Regenerative braking would not work either. Once safely parked it was making a loud high pitched whining noise. It would also drop RPMs while idling and then they would rev up quickly. Once the tow truck arrived he tried to drive it up on the flat bed but it had no power to make it up the ramp and had to be pulled with the tow cable up the ramp. Another thing I have noticed as of the last 68c update is that when in electric mode and merging onto a freeway for example, it gets really sluggish at about 65mph and the gas engine won't kick in like it used to before the update. It doesn't go above 65 and slows down to about 62 even if my foot is pedal to the floor before ice kicks in. Makes it pretty dangerous to be merging with traffic going 70+.