The digital instrument cluster and center infotainment display screen went completely black and blank while the vehicle was in motion. This immediate failure blinded the driver to critical safety telemetry, including the current vehicle speed, gear positioning, and active safety warning telltales, creating an immediate, severe crash hazard on the roadway.This symptom is identical to the failure condition detailed in active NHTSA Safety Recall Campaign 26V281000 for this exact model year. The vehicle is currently held at an authorized Mercedes-Benz dealership (Mercedes-Benz of West Covina) where technicians confirmed the physical screen and plug blackout but are actively refusing to execute the safety recall remedy without a $1,272.95 out-of-pocket consumer diagnostic fee, falsely claiming a localized cosmetic stain on a connection plug voids the manufacturer's obligation to repair a known, federally acknowledged factory software design defect.The vehicle remains unmodified, intact, and available for federal or corporate engineering inspection at the dealership location upon request. No warning lamps or symptoms appeared prior to the sudden screen blackout.

MERCEDES-BENZ E 350 2025 UNKNOWN OR OTHER

FIRE HAZARD â UNDERSIZED DC CABLE WITH UNDOCUMENTED SPLICE INSIDE PASSENGER COMPARTMENT  The 2026 Midwest Automotive Designs Luxe Cruiser D6 (VIN [XXX] , Unit #[XXX]) contains an undersized negative DC cable carrying 304 amperes continuous through a conductor rated for 195 amperes (2/0 AWG copper), representing 156% of rated capacity under NEC ampacity tables. Motor-starting surge loads can exceed 400 amperes (205% of rated capacity). This cable is the primary DC negative path between a 1,080Ah lithium-iron-phosphate battery bank and a Xantrex Freedom XC PRO 3000 inverter-charger. The hazard compounds at the floor penetration inside the coach passenger compartment: the cable transitions from properly-sized 4/0 AWG to undersized 2/0 AWG at a bolted lug splice wrapped in white electrical tape. This splice is located inside the vehicle where my family rides. It is not documented in any build record, inspection report, or repair order. Photographic evidence ([XXX]) reveals that both copper lug faces at this splice bear red X markings. These markings are not consistent with any recognized torque witness marking practice (which requires a stripe crossing from bolt head to mating surface). The marks represent either (a) failed-inspection flags placed by someone who identified the connections as defective and left them uncorrected, or (b) non-functional markings. Either interpretation establishes that someone examined these lugs, marked them, and walked away. The Xantrex Freedom XC PRO Ownerâs Guide (Rev G, Table 5) specifies minimum 4/0 AWG for cable runs of the installed length and classifies improper wiring under its highest safety designation (DANGER) as capable of causing âdeath or serious injury.â The Guide further includes a FIRE WARNING for DC connections that are not torqued to 71â89 in-lb. No torque documentation exists at any service touchpoint. ADDITIONAL SAFETY DEFECT: The interior 120V outlets are not protected by GFCI breakers as required  INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FO

MIDWEST AUTOMOTIVE DESIGN LUXE CRUISER 2026 ELECTRICAL SYSTEM

Drove the car through a 6" puddle and the engine was hydro locked, alternator and starter died leaving me stranded in the middle of the road. This car is in Florida and I would expect it to be able to go through a puddle. When getting the engine replaced I was told that my E350 was not the only one with this issue.

complaints.title