Steering feels sticky at higher speeds, once the vehicle is at full operating temp. The steering requires some pressure to “break free” from whatever position it is in. If I’m continually moving the wheel, it steers normally. However, if I’m driving straight and need to initiate a turn or make minor steering corrections (like on the highway), I have to turn the wheel harder than normal, then it gives way and turns with regular force. This makes it difficult to control, causing the car the jerk around a lot. This is an issue many others have noticed on online forums, and there does not seem to be a known fix for this. The Mazda dealership near me could not duplicate the issue (since it takes 20-30 minutes of continuous driving for this steering issue to get worse to the point of concern), and therefore refused to look any further. This makes it unsafe to drive longer than 20-30 minutes. I am currently awaiting an appointment with an independent service center. There are no warning lamps, messages, or other symptoms that I'm aware of

On 14th, 2026, while traveling at approximately 60 mph on the northbound 55 Freeway near the Katella exit, my vehicle suddenly began to shake violently without any prior warning. In response, I attempted to slow down by applying the brakes; however, the speedometer rapidly increased even as I maintained firm pressure on the brake pedal. Immediately afterward, the vehicle pulled sharply to the left, causing a complete loss of steering control and resulting in a collision with the center median barrier. Despite the force of the impact, the airbags did not deploy, raising additional concerns about potential safety system failures. At no point before the incident were there warning lights, alerts, or indications of mechanical or electronic issues. The vehicle had also undergone its regularly scheduled maintenance at the Tustin Mazda dealership on January 2nd, 2026, just prior to the accident. Given the sudden shaking, unintended acceleration, loss of braking effectiveness, steering failure, and non‑deployment of airbags, I believe this incident may involve one or more manufacturer defects affecting critical safety systems. I respectfully request that NHTSA investigate this matter. I also believe the vehicle’s Event Data Recorder (EDR) may contain information relevant to identifying the root cause of these failures.

Transmission failure when driving. Car was towed to dealership and diagnosed. Transmission and torque converter replacement required under factory warranty. Very long lead time for dealer to acquire replacement parts, about 4 months.

Manual transmission will not reliably shift from 2nd to 3rd gear without a grinding noise. Other owners are reporting similar issues that have required a full replacement of the transmission in MY2023 cars.