The vehicle experienced a sudden, catastrophic brake-by-wire system failure while operating in one-pedal driving (Regeneration Boost mode). While decelerating at a low speed behind an 18-wheeler semi-truck, the vehicle failed to continue slowing down. I immediately depressed the physical brake pedal, but the vehicle completely ignored the foot pressure. The pedal and braking system became completely unresponsive, and the vehicle kept rolling forward uncommanded. Despite keeping the brake pedal fully depressed, the vehicle did not decelerate, resulting in a front-end low-speed collision with the metal rear bumper of the semi-truck. Because the collision occurred at a very low speed, the operator of the commercial truck was unaware of the impact and safely continued driving forward without stopping. The vehicle's brakes entirely refused to re-engage until I frantically pumped the physical brake pedal and cycled/pressed vehicle control power switches. This action seemingly forced the electronic braking modules to reboot or re-establish hydraulic pressure, allowing the vehicle to finally come to a stop. The vehicle was subsequently removed from the active roadway. This is a severe, life-threatening safety defect involving a total loss of electronic brake-by-wire and friction braking application without any mechanical override intervention, presenting an extreme hazard. The vehicle has been towed directly to an authorized Toyota dealership for a comprehensive electronic diagnostic pre-scan of the Skid Control ECU, Electronic Parking Brake system, and 12-volt auxiliary power systems to retrieve the stored DTC fault logs and freeze-frame data.

While operating my 2024 Toyota bZ4X at very low speed on the road , I observed a stationary shipping container directly ahead and applied the brake pedal with maximum force approximately 4 seconds before contact. I held the brake pedal at full pressure continuously. I never touched the accelerator. The vehicle came to what appeared to be a complete stop then continued to advance and made physical contact with the container despite my maintained maximum brake input. The vehicle's own ECU-recorded Freeze Frame Data (retrieved by an authorized Toyota dealer using PCS Data Viewer) confirms the following at the time of the event: Driver brake pedal torque was at sensor saturation (4,048 Nm — the maximum value the sensor can record) for approximately 1.75 seconds prior to impact. Brake hydraulic line pressure peaked at 12.144 MPa and remained above 7.8 MPa throughout that period. Throttle position was 0.0% for the entire recorded interval. All four wheel-speed sensors recorded 0.00 km/h for approximately 2.95 seconds prior to impact. Steering input was effectively neutral; no skid or loss of directional control occurred. The longitudinal accelerometer recorded a peak deceleration spike of -8.97 m/s² at the moment of impact — a value that requires forward velocity and is physically inconsistent with the wheel-speed data showing the vehicle stopped. The Pre-Collision System (PCS) main switch was ON throughout, with no faults, no obstruction flags, and no warning, pre-brake, brake-assist, or auto-brake activation recorded. The Parking Support Brake (PKSB) did not activate. No diagnostic trouble codes were set. In plain terms: with maximum brake pressure applied and zero throttle input, my vehicle continued to move forward into a clearly visible stationary obstacle. The brakes did not maintain authority over the powertrain's creep torque, and no advanced safety system intervened. This indicates a potential defect in the vehicle's brake-override / creep-suppression

The car show on the screen a message in regards to the Adaptative Cruise Control Malfunction and it’s showing an orange sign light.. Another problem it’s in regards the AC.. it’s not working

The contact owns a 2024 Toyota BZ4X. When pressing the accelerator toelerator pedal to go onto the freeway, the vehicle failed to accelerate and suddenly shifted to neutral. The contact would have to press the brake pedal, the contact would immediately shift the vehicle back to Drive and continue forward. While continuing to drive, the vehicle accelerated. There were no warning lights. The failure had occurred 3 times. When attempting to start the vehicle one day, the vehicle failed to start. The tow company came and provided a jump-start, and then advised the contact to drive carefully, but if it failed to go in reverse. The next morning, the tow company's mechanic came again and confirmed battery failure, then recommended the vehicle be taken to the dealer. The vehicle was towed to the dealer, who stated that the battery had not failed, but had not provided a diagnosis for the failure. The vehicle had not been repaired. The dealer had driven the vehicle back to the contact's home. After the vehicle was returned, the failure occurred again. The manufacturer was informed, and a claim had been filed. The failure mileage was 9,787.

I LEASED A TOYOTA BZ4X THE PARKING BRAKE LIGHTS AND OTHER LIGHTS COME ON AND OFF WHILE I AM DRIVING AND FOB IS NOT TOUCHED. I TOOK CAR IN TO BE SERVICE FOR REGULAR MAINTENANCE AND WAS TOLD I HAD TO PAY $295 AND I AM UNDER WARRANTY. I WAS SOLD THE CAR BRAND NEW AND I DON'T THINK IT IS. I KEEP HEARING PEOPLE TALKING WHEN THE CAR IS POWERED OFF. I REPORTED THIS SEVERAL TIMES AND WAS IGNORED. MY CAR KEEPS TRYING TO CUT OFF WHILE I AM DRIVING AND THE CAR STARTS SHAKING, ALL THE LIGHTS COME ON THEN GO OFF. I WAS TOLD I COULD GET MY CAR SERVICE ANYWHERE FOR NO CHARGE UNDER WARRANTY. I WAS TURNED AWAY. ITS N BEEN A YEAR AND NO SERVICE CAR HAS NOT BEEN SERVICED AT ALL. I TOOK IT 2 TIMES FOR SERVICE AND THE CAR HAS NOT BEEN SERVICE. IT IS SUPPOSED TO BE NEW.