Rough idle started at 11,400 miles. Took to GMC dealer near me and had thrust bearing clearance measured. Measured .0054"(within spec). They released truck back to me. 19,400 mile oil change found large metal(non magnetic) slivers in the filter media. I cut filters to check for issues due to known issues with this engine(metal). I called gmc corporate, i was told to not drive the truck. I paid out of pocket for the tow 142 miles away. Dealer told me they checked thrust bearing and came in at .0055", no noises, and no check engine light. Idle is very rough on start up. GM corporate stated a service advisor will call. Never got a call. I have sent and displayed the evidence and offered to show oil filter contents to both dealer and corporaten both have not done anything about this safety issue. This is a SEVERE safety issue. Engine is highly likely to lock up and cause serious injury to both me, my family, and others on the road. Dealer has released truck back to me and my family with clean bill stating they didnt find anything wrong. They refused to see my documentation of metal slivers or the 3 rimg binder full of maintenance records. As of now i will be escalating this to higher up in GMC corporate. SEVERE safety risk for my family and everyone on the road. GMC dealers refusing to diagnose.

Either while stopping while driving or parking (forward or reverse) the engine RPMs go up thus wanting to move the vehicle in that direction causing the breaks needing to be applied harder. When you shift into neutral the RPMs go way up (3000). This has happened on this vehicle 3-4 times of which I have video of the latest occurrence. When put into R or D the RPMs are still over 1000. This also happened on the courtesy vehicle same make and model) I was given but on this one the RPMs went up to 5000 of which I also have a video. The dealership has not been able to duplicate the issue as of yet. My fear is that the vehicle will hit someone or something if the break isn't pressed to the floor. It happens very randomly. The dealer currently has my vehicle trying to figure it out. They say GM says there's nothing they can do. No warning lights or messages appeared.

In normal operation on Tuesday May 26,2026, the engine experienced catastrophic failure. The engine is the GM L87 6.2 Liter. This was on a highway in the country and I was able to maneuver the truck off the road before an accident occurred. It did leave me stranded and I was required to get it towed on a roll off (It was not drivable) to the dealer where I purchased it. The dealer [XXX] ) inspected my truck and has informed me that the issues with my 2025 Sierra match the issues for the recall GM had for the model years 2021-2025. It will require a new engine, radiator, among many other parts. There weren't any previous warnings. A check engine light only came on once the engine was engine came apart. An oil change on the vehicle by GM was done a month ago. The truck is a 2025 and has approximately 6,600 miles is all. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

6.2L crankshaft failed

15000 miles and the engine spun a bearing and the engine blew