The driver's side mirror vibrates when the vehicle is at speed. I've been to two dealers who say that it's normal, and everything is intact and installed correctly. When driving, the mirror vibrates a lot, which is a safety issue when trying to use the side mirror during changes, etc.

The contact owns a 2024 Toyota Sienna. While the contact’s wife was driving 5 MPH out of a parking lot and attempting to make a left turn, the vehicle suddenly lost motive power and stalled. After approximately 3- 4 seconds while depressing the accelerator pedal several times, the vehicle eventually accelerated as needed. The vehicle was driven to the residence. There were no warning lights illuminated. The vehicle was not taken to the dealer to be diagnosed or repaired. The manufacturer was not informed of the failure. The failure mileage was 68,000.

When a lever is pulled, the second row seat can move freely back and forth on a track until the back of the seat is returned to the upright position. I was driving at highway speeds and had to brake suddenly. The seat was at the back of the track with the lever pulled, and it slammed into the back of the driver seat, hurting my back. It stuck there putting pressure on the seat (which could be felt) until I stopped and had to use force to make it slide back.

The driver side power sliding door failed to detect my [XXX] and ended up squishing it and we struggled for over a minute for the door to open. I have a video of the incident as it was captured by our security cameras, but I cannot upload it here. This was no the first time the doors have failed to detect someone. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Keeps bottoming out suspension is specification is stated at 5.6 inches and I measured 3.3/4 unloaded never get a response on my complaints from my last repair and resolution on what they admitted that suspension was too low and wouldn’t put it in writing only saying that vantage mobility saying that it’s height requirements are as stated by vantage but no mention of ground clearance that I wanted them to verify that it’s specifications are stated at 6.5 inches and i measured 3 3/4 empty then they tell me not to go by specs and I’m a retired from wright Patterson Air Force base in the engineering department with logistics command and I’m like really guys you have to to have a specifications for a engineered system and they can’t even call back after they admit you have to go by specs! And then the authorized repair specialist tells me i had a bad brace on the front tire that was welded wrong and didn’t even mention it on the invoice or reported it to vantage mobility to call me about anything I had concerns about ?