On June 1, 2026, software update 68C was performed at the dealership on my 2025 Jeep Wrangler 4xe. On June 6, 2026, at approximately 9:00 a.m., after driving the vehicle for about 25 minutes, I experienced a serious malfunction. While making a turn at a speed of less than 10 mph, the vehicle suddenly and without warning lost throttle and propulsion. It appeared to hesitate as though shifting between electric and gasoline power, and then abruptly and erratically lurched forward, accelerating to what felt like maximum speed. The Jeep struck a chain-link fence, which slowed its movement, but it continued to surge forward. I applied the brakes and attempted to maintain control of the vehicle, but it kept lurching ahead. At no point did the vehicle emit a safety warning, sound an alert, or attempt to stop automatically, even though it normally responds to obstacles when operating properly. I repeatedly attempted to place the vehicle in reverse, but it did not respond. I turned the engine off and back on several times, and only after more than three attempts did the vehicle finally recognize reverse, allowing me to back away from the fence. A man in a truck assisted me and contacted the police. Both the responding police officer and the assisting individual expressed concern about the potential danger, particularly because the vehicle is a 4xe. I am now extremely hesitant and fearful to operate or move the vehicle. The vehicle is available for inspection and has not been inspected yet by dealership or insurance. I have it parked outside of my residence.

Component/System Failure: The hybrid/electric propulsion system intermittently loses power while driving. Electric output is progressively reduced to approximately 50%, then 25%, and then fully disabled, even when sufficient battery charge remains. The condition appears to involve the hybrid control/electric drive system. The vehicle is available for inspection upon request. What Happened / Safety Risk: The loss of electric propulsion occurs unpredictably during normal operation, including both highway and city driving. The reduction in available power and sudden loss of electric functionality creates a potential safety concern, particularly when driving in traffic or at higher speeds, where reduced or inconsistent propulsion may impact the ability to maintain speed or respond to driving conditions. Additionally, the vehicle is subject to a high-voltage battery recall involving fire risk, which raises concern regarding safe operation and storage of the vehicle. Reproduction / Dealer Confirmation: The issue has been reproduced and confirmed by the dealership (Johnson Auto Plaza, Brighton, CO). The dealership also confirmed that the same issue was reproduced on another Jeep Wrangler 4xe vehicle on their lot. Inspection by Manufacturer / Others: The vehicle has been inspected by the dealership and escalated to Jeep Engineering. The manufacturer has been unable to diagnose the issue due to the absence of diagnostic codes and has not identified a repair. Warning Lamps / Messages / Symptoms: No consistent warning lamps or diagnostic codes are present when the failure occurs. The loss of electric functionality happens without a predictable pattern and without clear diagnostic indicators. Additional Notes: The issue occurs unpredictably under all normal driving conditions, including: Highway driving at speed City driving at low speed Various battery charge levels (low and high) The dealership has suggested possible driver-related causes; UNsupported by car behavior

We were at a complete stop, with foot on break when my jeep lunged forward twice , second lunge hit the vehicle in front of me, also that car was at a complete stop. It has lunged 2 other times while at a complete stop .

My dealership (Jeep Bayside Annapolis, MD) is refusing to fix the recall. They say they’ve had issues with some of the cars, and it’s taking too long. They said they’ve are capable of fixing the recall, but are refusing to do so.

Subsequent to the 68C recall software update, my vehicle is suffering from intermittent loss of acceleration. Even with a full charge of battery, when driving the 2025 jeep wrangler 4xe in EV mode, occasionally the car will shut of EV mode and transition to gas/hybrid mode. The problem is the vehicle changes from EV mode to gas/hybrid it can take 10 seconds. In the meantime there is no ability to accelerate. The pedal is dead. It occurred 4 times in random places. Once on a regular country road, Once straining on a steep hill Once merging with traffic on the highway The last time I drove it was when I lost acceleration while making a left hand turn on a busy intersection. It would have been a head on collision if the other driver hadn't slammed on their breaks. This was my last time with the vehicle and it has been sitting at the dealership since January. The dealership service department tells me Stellantis is not working on a fix for this issue, even though it is a serious safety defect. Since then I have been pursuing lemon law however this process is taking forever. They refused to provide a loaner car. I was renting a vehicle but it was too costly. I ultimately had to buy another vehicle, even thought I spent $70,000 on a brand new jeep that is sitting at a dealership. They claim no fault found. The dealership drove it a total of 10 miles in EV mode. No fault found. They are putting people in danger and making us QA test while they push out software updates that aren't tested in the real world. This vehicle is trying to kill me. It will either explode and burn down the house or cause a collision. They need to make this right. Please help.