A defective set of spark plugs with certain model year 2023 Toyota GR86 to have premature failure. While driving at highway speed spark plug blew up resulting in a cylinder 4 misfire and loss of drivability. The service advisor from the Toyota dealership unofficially confirmed this has happened to multiple other gr86 models. Along with being unofficially confirmed by an aftermarket specialist. Original diagnostic from the dealership was to replace the motor due to all of the issues, while a local certified mechanic has replaced the spark plug, coil pack, and is continuing to troubleshoot as the head gasket also needs to be replaced. No warnings lights or signs were present prior to failure.

Fuel lines in the engine bay are rubbing against the hood insulation and wearing down. The first generation GR86 fuel lines had sleeves compared to the second generation..

There are two fuel lines on each side of the engine bay, driver and passenger going into the injector rails. One of the fuel lines on the driver side is rubbing on the underside of the hood, when closed, causing marks, and potentially a burst on a fuel lines, causing fires. The fuel line on my car has rub marks, and visually “wearing it down”. No bursts, yet. There has been about 10-15 cases of GR86/BRZ (essentially the same car), with fires starting randomly from the engine bay on the driver side, rising the chances of this being a reality, and a VERY SERIOUS issue with these cars. And with this issue arising from FB groups, many other owners have come forward and confirmed the same rubbing marks on the same fuel line, or even in both on the same side instead of just the one.

Fuel lines on right hand side of engine bay (when viewed from front of vehicle) show signs of wear due to contact with other components. I am unsure what components exactly, but wear significant enough to cause material removal from EPDM fuel line outer sleeve.

The contact owned a 2023 Toyota GR86 Sport vehicle. The contact stated that while driving 139 MPH for a couple of minutes, the vehicle stalled. Several unknown warning lights were illuminated. The contact was able to pull to the side of the road. The vehicle failed to restart and was towed to the dealer, where it was diagnosed that the engine had failed and needed to be replaced. The contact stated that the vehicle was covered under warranty; however, the dealer informed the contact that the repair could not be covered under warranty because the engine failure occurred due to customer abuse. The contact stated that the vehicle was designed with a maximum speed of 140 MPH. The contact was charged a repair fee, and the vehicle was traded for another vehicle. The manufacturer was not notified of the failure. The failure mileage was approximately 33,000.