So the ultimate failure is from a catastrophically failed crankshaft journal thrust bearing. Which could be caused from one of two things: 1) The crankshaft thrust bearings they are putting in these motors are made with inferior materials, probably cheap Chinese crap or 2) The crankshaft end play tolerance was never set properly, giving the crankshaft the ability to move forward and backward in the engine more than it was designed to. Which will over time beat up on the thrust bearing until it fails. In either case it would result in the same progressive issue showing itself. It will start as a squeak here and there. Which, as the soft thrust bearing material is unable to hold the proper oil film thickness for lubrication, will spiral into more and more heat being sent into the adjacent components, plus the buildup of metal particles being sent through the entire engine oiling system. Which will then start killing connecting rod and crankshaft bearings one by one. If the engine survived to this point, itâs now a ticking time bomb. It is either going to just seize up and not run anymore or the exciting route would be a connecting rod breaks and makes a window sized hole in the side of the engine block.

GMC YUKON 2026 ENGINE

The contact owns a 2026 GMC Yukon. The contact stated that while driving at 65 MPH the engine seized. All the warning lights illuminated after the failure. The vehicle was towed to the local dealer, where it was diagnosed that an engine replacement was needed. The vehicle was not repaired due to the part being backordered. The manufacturer was not contacted. The failure mileage was approximately 10,000.

Engine starting clicking during highway drive then engine failed mid-drive and engine was trying to restart on its own mid drive. Vehicle totally stalled out in the street, with numerous attempts the engine did not start. Total mileage on car was 2,900.

2026 Yukon Elevation with 3,957miles. I was driving down the road and pulled into the turn lane at an intersection. Vehicle cut off with the Auto Start/Stop function and would not start back up. I continued and tried to restart the vehicle but would not start; I was blocking the lane with cars continuously going around me. Vehicle stated service transmission on the display- I was unable to put it into neutral to push it out of traffic; You are only allowed to put it into neutral when crank  and couldnt get the accessory mode to come on without the vehicle trying to start. I called the local police department and they sent an officer to direct traffic until a tow truck showed up. Both observed the vehicle not starting.  There were no symptoms prior to the vehicle cutting off, only once auto start/stop initiated did the vehicle not restart.   Vehicle will be sent back to the dealership tomorrow to resolve this issue. I have dash cam footage of the incident and photos of the display on the screen.

complaints.title